Table of Contents
Advertisement
2.3. Handle installation
50-150A
Attach the handle with its tip pointing at the "SHUT" position, and fix it with a flat
head screw.
200-300A
Align the holes of the handle and the shaft. Insert the pin and hit it with a
hammer to fix them.
Handle
Shaft
3. Installation
3.1. Cautions for installation
⚠Caution
(1) Install the valve so that the directions of the flow and the arrow shown on the product
match.
(2) Do not disassemble the product unless it is necessary.
*Disassembly may prevent the product from functioning properly.
(3) Use sheet gaskets when connecting the valve to pipes.
*Using other types of gasket may cause fluid leak.
(4) Connect the product firmly so that the fluid will not leak.
*If connection is not firm, fluid might leak by vibration. Hot fluid may cause burn.
*Tighten the bolts uniformly in diagonal order.
(5) Connect the product so that it is not subject to excessive load, bending and vibration.
*They may seriously shorten the lifetime of the product.
(6) If freezing is possible, take antifreeze measures such as draining or insulation.
*The frozen fluid may damage the product.
Flat head screw
Handle
SHUT
Pin
-4-
OPEN
■EPDT-383■
Advertisement
Table of Contents
