Storage; Installation; Installation For Body Part - Yoshitake CT-1 Product Manual

Table of Contents

7. Storage

Please storage the product in the package by installation. During storage, please follow

these points.

* After open the package for checking product, please storage into original package

again.

* Do not storage the product where rain falls, temperature is above 60℃, and dust or

mist make damage for the product.

* Before installation, do not remove seal and plastic cap which is used for pneumatic

and electrical connection.

Warning

(1) Due to heavy product, make sure to use hanging machine to hold the product. When

hang this product up from package, use adequate hanging belt.

Eye bolt is installed at actuator in aim of hanging. When using eye bolt, use both

eyebolt and make hanging belt same load at both side. (See Fig.4)

Besides, do not hold positioner when installation.

*Otherwise product may fall and cause injury.

Hanging belt

Shackle

Eye bolt

Fig.4

-8-

■ EPDT-318a ■

Table of Contents