Table of Contents
Advertisement
Note:
The door status of open, close, remain open, and remain close cannot be triggered
at the same time.
3. Click Save button to save parameters.
Card Linkage
Steps:
1. Click to select the linkage type as Card Linkage.
2. Select the card from the dropdown list and select the access control device as event source.
3. Select the card reader from the table for triggering.
4. Set the linkage target, select the access control device from the dropdown list as the linkage
target, and switch the property from
Alarm Output: The alarm output will be triggered for notification.
5. Click Save button to save parameters.
Door Status Management
7.11
Purpose:
The door status of the added access control device will be displayed in real time. You can check the
door status and the linked event(s) of the selected door. You can control the status of the door and
set the status duration of the doors as well.
7.11.1
Access Control Group Management
Purpose:
Before controlling the door status and setting the status duration, you are required to organize it
into group for convenient management.
Perform the following steps to create the group for the access control device:
Steps:
1. Click
on the control panel to open the Device Management page.
2. Click Group tab to enter the Group Management interface.
Main Elevator Controller User Manual
to
91
to enable this function.
Advertisement
Table of Contents
