Table of Contents
Advertisement
Card Reader Status
Event Trigger Status
Alarm Output Status
Auxiliary Function Status
Distributed
Controller
Status
6.3.2 Network Settings
Setting TCP/IP
Steps:
1. Click Network Settings -> TCP/IP Settings to enter the TCP/IP Settings page.
2. Check or edit the device network parameters. You are able to set the NIC type, the device IPv4
address, the subnet mask, the default gateway, the DNS1 server address and the DNS2 server
address.
You can also check the MAC address and the MTU.
Main Elevator Controller User Manual
Button Relay Status: Open, Close
Card Reader No.
Online Status: Online, Offline
Tamper-Proof Status: Open, Close
Verification Type: Card, Card and Password, Card
or
Password,
Password,
Fingerprint, Card and Fingerprint and Password,
Employee ID and Password, etc.
Event Trigger No.
Status: Triggered, Not Triggered
Alarm Output No.
Status: Triggered, Not Triggered
Power Supply Status
Card Added
Main Controller Tamper-Proof
Elevator
Distributed Elevator Controller No.
Connection
Status: Online, Offline
Fingerprint,
Card
or
Fingerprint,
22
Fingerprint
and
Card
and
Advertisement
Table of Contents
