6. Major ssemblies Removal
Refer to Figure 7-59.
1. Complete \1. Preliminary Steps", \2. Front Panel Removal",
\7. J1 RF Output Connector Removal", and \5. Rear Panel Removal" before continuing.
2. Remove the six screws from the regulator shield.
3. Remove the shield.
4. Cut the tie wraps holding the cables attached to the PC assemblies.
5. Disconnect all cables attached to the PC assemblies.
6. Disconnect semi-rigid cable W54 from the A6 assembly.
All cables are labeled for easy reassembly. For identication purposes, the
Note
extractors on the PC assemblies are color-coded to indicate their assembly
number.
7. Pull out all PC assemblies.
7-72 Disassembly and Replacement Procedures
Motherboard
Figure 7-59. Major Assemblies
Agilent 8360