Do
Note
not
unchanged for the program to run properly. he factory recommended
\Zero Hr" is 1.00 and the \Cal Hr" is 24.00. Use the left and right arrows to
move the cursor within a eld and the up and down arrows to increment or
decrement the value.
5. When all changes have been made, select save power meter conguration.
6. Next select power meter calibration factors to add the power sensor calibration factors to
the program.
7. Select current to change the active power sensor to the one for which you would like to
enter the data.
8. Select edit header and enter the serial numbers of the power sensor.
9. Select edit calibration factors.
Agilent 8360
edit the \Sensor ID". he names set at the factory must remain
RETURN
selects the eld.
5
Automated Tests 5-15