Figure 32 Controller Wiring - ABB CPS3200U Product Manual

Step
Attach signal wiring to the controller at connector P6. The Ethernet connection to the local network is made
through the P6 RJ45 connector. Of the two RJ45s on the left side of the controller, P6 is the one more toward the
front labeled: P6 10/100 Base-T. Plug the local network cable into P6. As shown here:
To check the network connection, use the controller display to determine what IP address has been assigned to
7.
the QS941 controller. Press the square key, , on the upper right hand corner of the keypad to display the menu.
8. Press the down arrow key,
9. Press the right arrow,
Press the down arrow key, , 8 times to scroll down to the "Network Settings" item and select by pressing the right
10.
arrow key.
11. Press the right arrow,
12. Press the right arrow,
13. Read and record the network address for Port 1
When an IP address is listed connection to the server is confirmed
Page 42
© 2021 ABB. All rights reserved.
, 2 times to scroll down to the "Status" item on the menu
, to advance to the "Status" menu
, to advance to the "Network Settings" menu
, to select Port 1. The P6 connector is Port 1.
Action