Step 6 - Controller Connections - ABB Infinity S Quick Start Manual

QUICK START GUIDE
Alarm Relay jumpers Factory Defaults Open On Alarm
Step 5 - Set Controller Jumpers
Set jumpers 1 thru 10 for the ten alarm relays as Close on Alarm or Open on Alarm; Factory default setting is
Open on Alarm.

Step 6 - Controller Connections

Connect per site engineering instructions.
Alarm Wires See Information: Controller Connections
J4 OFFICE ALARM Alarm Outputs
J3 INPUT ALARM Alarm Inputs
LAN
J5 LAN Ethernet LAN or local PC connection
Modbus RTU Interface
Connect and configure Modbus RTU Interface per Pulsar Plus Modbus RTU Interface Quick Start Guide.
1-Wire Battery Temp and Voltage Monitor - Optional
J2 1-Wire Data See Information: Battery Monitoring Connections.
Step 7 - Install Rectifiers and Converters
Page 6
© 2021 ABB. All rights reserved.
J5 LAN
Controller Jumpers and Connections
J3
J4
Alarm
Alarm
Inputs
seat the converter. Verify the
J2 Thermal
probes
Modbus RTU
Interface
closed to fully