Table of Contents
Advertisement
www.glp.de
To install barndoors:
1. See Figure 7. Pull back the spring clip (1) on the top of the fixture and slide the barndoor
accessory into the channels (2) provided on the left, right and bottom of the fixture lens.
Release the spring clip and ensure that all four sides of the barndoors are correctly held
in place.
2. Install a safety bond between one of top corners of the barndoors assembly and the
main fixture to prevent the barndoors falling if they become detached from the main
fixture.
Installing color filter frame
An optional color filter frame accessory is available for the XPAR 12Z that can be installed
on the front of the fixture. This would normally be used to hold diffusion or frost media to
soften the light beam.
The procedure to install the frame is the same as for the barndoor accessory above.
22
Connecting to DMX data
Fusion XPAR 12Z Quick Start and Safety Manual Rev. A
Advertisement
Table of Contents
