Table of Contents
Advertisement
www.glp.de
4. Installation
Warning! Read 'Safety' starting on page 5 for important safety information that
you must understand before you install or operate the fixture. Install XPAR 12Z
fixtures only as described in this chapter, or you may create an installation that is
unsafe.
Install the fixture at least 0.2 m / 8 in. away from combustible materials (wood,
textiles, paper, etc.), 0.2 m / 8 in. away from any surface that will be illuminated,
and a safe distance away from any flammable materials (volatile spirits, etc.).
It is the installer's responsibility to provide a stable, secure supporting structure
that is suitable for the environment and application and that meets all
applicable codes and legal requirements. Note the requirement to secure
lighting fixtures with safety cables in temporary installations.
Permitted mounting options
An XPAR 12Z fixture may be installed in one of the following ways:
1. Fastened to a surface at any angle by screwing through the mounting bracket.
2. Fastened to a rigging truss or similar structure at any angle by means of a truss coupler
or other clamp fixed to the mounting bracket.
3. Free standing on a flat surface by splitting apart the two sections of the mounting
bracket to form two feet.
4. Free standing on a flat surface by standing the fixture on its back pointing upwards.
Securing fixtures with a safety cable
In temporary installations, if a fixture could cause injury or damage by falling you must
secure it with a secondary attachment such as a safety cable that will hold it if the primary
means of attachment fails. The safety cable must be approved for the weight that it
secures.
14
Installation
Fusion XPAR 12Z Quick Start and Safety Manual Rev. A
Advertisement
Table of Contents
