Installation - Presto Lifts Dock Lift Series Owner's Manual

4

Installation

Installation of this machine shall be performed by trained and/or qualified personnel only.
The owner/ installer is responsible for obtaining any necessary permissions and/ or permits.
Follow all applicable codes and ordinances. Read and understand all safety and installation
information in this manual.
Before installation, remove all shipping materials and verify all components on the packing
list were received. Inspect the machine, all components, wiring and electrical connections,
hydraulic hoses and fittings for damage. If components are missing or damage is found contact
the manufacturer before continuing installation. If not being installed in a pit see Typical and
Alternative Pad Plan sections.
High Voltage: Electrical service and installation must be performed by trained and/
or qualified personnel. Lock-out/tag-out the power source before installation.
Electric motors can create sparking, do not install in an area where flammable
materials are present.
Never enter beneath the platform unless the machine is unloaded and secured
against lowering using the maintenance device. If unable to engage the
maintenance device the platform must be secured against lowering by other
means.
All electrical components and the hydraulic power unit must be protected from wet
and/or dirty environments unless specifically configured for such environments.
Pinch points and crush hazards exist when moving and transporting the machine.
Do not enter under any equipment while moving or transporting. Keep hands, feet,
and loose clothing away from moving equipment.
This machine must be installed on a solid, stable, level surface or machine will be
unstable and can lead to injury. Do not install on asphalt or other unstable surface.
Use appropriate lifting device to lift the machine. Use a load spreader to lift the
machine. Lift the machine using the provided lifting eyes only. Do not lift the
machine by the platform, unless using the specific instructions provided in steps 1
through 6.
This machine must be properly secured to the floor/ground before operation or the
machine may be damaged.
Presto Lifts
See Section 6.1 Maintenance Device on page 24.
See Section 4.6 General Installation on page 17.
12 PDL Dock Lift Manual