Wali MF003S Instructions

INSTALLATION MANUAL
Triple Monitor Desk Mount
MF003S
Supplied Parts List
Lower Pole Upper Pole Weighted Base
a1 (x1) a2 (x1) b (x1)
M10 Washer Spring Washer Grommet Base Plate
k (x1) l (x1) m (x1)
2
Option A: Free Standing Installation (Using V-vase)
Install the Pole a to the weighted Base b using 3pcs M5x14 Bolts e , and tighten with the Allen key 3mm o . a1 b
a1
e
o
www.walielectric.com
support@walielectric.com
1-844-SATTLER (18447288537)
(10kg/22lbs)x3
75x75\100x100
Swivel Arm Monitor Arm VESA Plate
c1 (x1) c2 (x1) d (x3)
Wire Clip Wire Clip Allen Key
n1 (x2) n2 (x4) o (x1)
e
b
√
WARNING
！
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect
assembly or inappropriate use.
TIPOVER WARNING
！
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
● NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR STAND.
RATED
● USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL.
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.
SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
M5x14 Bolt Nut M10 Bolt Support Plate
e (x3) h (x3) i (x1)
Wrench M4x12 Bolt M4x30 Bolt
p (x1) q (x12) r (x12)
To provide stability for a heavier monitor, we may recommend install the mount to the hole in your desk.
a: Existing Grommet Hole Installation
1
Loosen the screw on the Lower Pole
Lower Pole to Upper Pole
a1
2mm o to fix the two poles. o
Pre-Assembly
j (x1)
a1
M4 Spacer
s (x12)
This step is depending on your personal preference
b: Self-drilled Hole Installation
OR
0.4''-3''
j
k
l
i
p
a1 with Allen key 2mm o . Connect o
and tighten the screw with Allen key
a2
o
o a2 a2
o
o
a1
a1
ø 10m m
(ø 3/8 ")
0.4''-3"
j
k
l
i
p