Wali MF002XLS Installation Manual

INSTALLATION MANUAL
Dual Monitor Desk Mount
MF002XLS
Supplied Parts List
Lower Pole Upper Pole Weighted Base
a1 (x1) a2 (x1) b (x1)
M10 Washer Spring Washer Wire Clip
k (x1) l (x1) n1 (x2)
Option B : 16.3'' Pole Installation (Only Used For Single Monitor Mount)
Press Pole Cover into the top of Lower Pole a1 .
n2 t a1
Pre-Assembly
a1
www.walielectric.com
support@walielectric.com
1-844-SATTLER (18447288537)
(10kg/22lbs)x2
75x75\100x100
Monitor Arm VESA Plate
c (x2) d (x2)
Pole Cover Allen Key Wrench
n2 (x1) o (x1) p (x1)
2
Option A : Weighted Base Installation
1a. Install the Lower Pole a to the weighted Base b using 3pcs M5x14 Bolts e ,
and tighten with Allen key 3mm o .
n2 t
！ WARNING
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect
assembly or inappropriate use.
！
TIPOVER WARNING
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
● NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR STAND.
RATED
● USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL.
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.
SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
M5x14 Bolt Nut M10 Bolt
e (x3) h (x2) i (x1)
M4x12 Bolt M4x30 Bolt M4 Spacer
q (x8) r (x8) s (x8)
b
a1
a1
b
e
o
1
Option A : 31.5'' Pole Installation
Loosen the screw on the Lower Pole
Lower Pole to Upper Pole
a1 a1
2mm o to fix the two poles. o
Pre-Assembly
o
Support Plate
j (x1)
a1
a1
Grommet Base Plate
t (x1)
e 1b. Optionally, you can drill a 10mm diameter hole in your desk and secure using the
Support Plate j , M10 Washer k , Spring Washer k
provided Wrench p .
p
p
a1 a1 with Allen key 2mm o . Connect o
and tighten the screw with Allen key
a2 a2
a2
a2
o
a1
l and M10 Bolt i . Fasten M10 Bolt i i with
ø 10mm
(ø 3/8 ")
j
k
l
i