Wali MF002 Installation Manual

INSTALLATION MANUAL
Dual Monitor Desk Mount
MF002/MF002-W
Supplied Parts List
Pole Weighted Base
a (x1) b (x1)
Spring Washer
Grommet Base Plate
l (x1)
m (x1)
1
Option A: Free Standing Installation (Using V-vase)
Install the Pole a to the weighted Base b using 3pcs M5x14 Bolts e , and tighten with the Allen key 3mm o . a b
a
e
o
www.walielectric.com
support@walielectric.com
1-844-SATTLER (18447288537)
(10kg/22lbs)x2
75x75\100x100
Swivel Arm VESA Plate
c (x1) d (x2)
Wire Clip Wire Clip
n1 (x1) n2 (x4)
e
b
WARNING
！
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect
assembly or inappropriate use.
TIPOVER WARNING
！
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
RATED
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.
SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
M5x14 Bolt Nut
e (x3) h (x2)
Allen Key Wrench
o (x1) p (x1)
To provide stability for a heavier monitor, we may recommend install the mount to the hole in your desk.
a: Existing Grommet Hole Installation
M10 Bolt
i (x1)
M4x12 Bolt
q (x8)
This step is depending on your personal preference
b: Self-drilled Hole Installation
OR
0.4''-3''
j
k
l
i
p
RT OF MONITOR OR STAND.
M10 Washer
Support Plate
k (x1)
j (x1)
M4x30 Bolt M4 Spacer
r (x8) s (x8)
ø 10m m
(ø 3/8 ")
0.4''-3"
j
k
l
i
p