Page 4
快速安装手册 ●安装 Installation 安装方法: 请根据打印机的安装尺寸在设备上开孔或预埋 4 个螺丝,然后把打印机固定架认准方向套 在 4 个螺丝上,并用配套螺母拧紧固定(如果在震动颠簸环境使用,建议螺母下加装弹簧 垫) 。 101mm(W)×40mm(H) 。 开口尺寸: Installation Method Fix the printer holder onto the embedded four screws of the device, then tighten the nut. Installation Dimension 101mm(W)×40mm(H) 。 : ...
Page 5
Attention: Do not connect AC to the printer directly, operating voltage should be within ± 5% rated voltage. Power polarity must be correct, otherwise it will cause permanent damage to printer, brightek company do not assume maintenance compulsory upon this.
Page 6
快速安装手册 ●装纸 Paper Roll 安装步骤: 1.如图 1 箭头方向,用手指夹住两侧的弹性卡扣,并将打印单元从打印机固定架中抽出。 2.将纸轴装入纸卷,然后装入打印机纸仓内,将纸轴两边固定在卡槽内(如图 3),同时注意 纸的方向有药液的一面(光滑面)向下(如图 2) 。 3.把打印纸装入后并拉出一截,将纸插入入纸口内,注意把纸放整齐。 4.开机,按下 LF 键使机头转动,如果纸走歪,再按下 LF 键。 5.把打印单元推入复位。 Replacing the Paper Roll 1. As the Fig.1 show, champ the button both sides with fingers, and draw out the printer unit.
Page 7
快速安装手册 ●清洁 Cleaning 清洁保养: 热敏打印机使用久了以后,热敏条与滚轴上会留下一些污垢,如果不及时清理会影响到打 印机的使用与寿命。我们建议您不定期做好清理。方法是打开纸舱盖,用棉棒沾少许酒精, 轻轻擦拭打印机热敏头,及纸仓上的滚轴。 Printer Cleaning If the interior of the printer is dusty, print quality can decline. So please clean the printer regularly. Open the cover of printer, then Wipe the print head with a cleaning pen and Use a cloth moistened with an alcohol solution to clean the paper sensor and the platen roller.
Page 8
●产品规格一览表 Product Specification 项目 ITEMS 规格 SPECIFICATION 打印方式 Printing method 行式热敏打印 Direct thermal line printing 纸宽 Paper width 57mm 打印宽度 Print width 48mm 分辨率 resolution ration 8 dots/mm (384 dots/line) 打印头寿命 life of printing head 6,000,000 character lines 打印速度 Printing speed 50mm/sec (when the utilization rate is 25%) 字符大小...
Need help?
Do you have a question about the U01 and is the answer not in the manual?
Questions and answers