SAESHIN Traus SIP10 Instruction Manual page 9

BUTTONS ON THE OPERATION PANEL
Program Button:
Use for selecting the set program number. (+) button for 1 stage up and (-) button for
1 stage down.
Speed Button:
Use for setting the speed (RPM).
(+) button for 1 stage up and (-) button for 1 stage down. Keep pressing speed button to
change the stage rapidly.
* The setting range of speed is different from the gear ratio.
Torque Button:
Use for setting the torque according to the various use such as drilling or tapping.
(+) button for 5 N·cm up and (-) button for 5 N·cm down.
* The setting range of torque is different from the gear ratio.
Memory Button:
Keep pressing Memory button after completed setting. Then the condition is memorized
with beep sound.
Gear Ratio Button:
Use for setting the gear ratio of the angle handpiece.
> 1:4 -> 1:5 -> 1:1 -> 16:1 -> 20:1 -> 27:1 -> 32:1 -> 64:1
Operation Direction Button:
Use for selecting the forward or reverse direction. The beep sound is heard during
rotation in reverse direction.
Irrigation Pump Button:
Use for setting the irrigation volume in 5 levels (From 0 to 90ml).
Irrigation Level
0 1
Optic Button:
When press the speed control pedal on the foot controller after operating the optic function,
LED is turned on at the angle and motor parts.
Release the speed control pedal, turn off the LED after 3 seconds.
Turn off the optic function, LED is not operated regardless pressing the speed control pedal.
Optic function is only operated by Optic angle handpiece and Optic motor .
Water Pump
2 3 4
Stage 0: 0 ml/min
Stage 1: abt. 40 ml/min ± 20%
Stage 2: abt. 55 ml/min ± 20%
Stage 3: abt. 70 ml/min ± 20%
Stage 4: abt. 90 ml/min ± 20%
14