Shutting Down The Unit; Warranty; Information On The Engine - MTD 13B721SD600 Manual

Shutting down the unit

Lubricate the wheel bearings and front wheel axes
■
with a multipurpose grease applied to the grease
nipples.
Every 50 operating hours
Dirt and grass remnants must be removed from
■
the drive gear by a specialist workshop.
If required
Charge the battery
If you are not using the device for a prolonged
period, removal of the battery from the device and
charging prior to storage is recommended, as well
as every 2 months during storage, and before start-
ing up the device again.
Note
Follow the instructions in the operating man-
ual for your battery charger.
Replace fuses
Replace defective fuses only with ones of an
■
equal rating.
Once a season
Apply multipurpose grease to the teeth on the
■
steering gear.
Lubricate the steering linkage with a few drops of
■
light oil.
Lubricate all rotating and bearing points (operating
■
lever, height adjustment of the cutter deck ...) with
several drops of light oil.
Clean the spark plug and check the gap between
■
the electrodes or replace the plug. See engine
handbook.
The rear axles must be lubricated with a spe-
■
cial-purpose (water-repellent) grease in a spe-
cialist workshop.
The cutting blade must be sharpened or replaced
■
by a specialist workshop.
Shutting down the unit
Caution
Material damage to the device
Only store the device
once the engine has cooled in a clean and dry room
or area.
During prolonged storage, e.g. in winter, ensure that
the device is protected against rust.
After the season or if the device will not be used for
more than a month:
Clean the mower and grass catcher attachment.
■
Wipe all metal parts with an oily rag or spray them
■
with oil to protect them from rust.
Charge battery with a battery charger.
■
When shutting down the appliance for the winter,
■
remove the battery, charge it and store in a dry/
cool location (protected from frost). Charge the
battery every 4–6 weeks as well as before re-in-
stalling it.
Drain the fuel (outdoors only) and shut down the
■
engine as described in the engine manual.
Inflate tyres according to the specifications on the
■
tyre walls. If tyres have no specifications on the
tyre walls, inflate to a pressure of 0.9 bar.
Store the mower in a clean, dry room.
■

Warranty

The warranty rules issued by our company or the
importer apply to every country.
Under the terms of the warranty we will repair faults
on your device free of charge, insofar as material or
manufacturing defects are the cause.
To make a claim under warranty please contact your
seller or your nearest branch.

Information on the engine

The engine manufacturer is liable for all engine-re-
lated problems with respect to power, power mea-
surement, technical specifications, warranty and
service. Information can be found in the owner's/
user handbook supplied separately by the engine
manufacturer.
EN
17