Table of Contents
Advertisement
8. External Interfaces
8.1. Ethernet
Four 10/10/1000 Mbps and two 1/10 Gbps, Cat6-rated Ethernet jacks are provided. Any Cat5e-rated
or higher Ethernet cable of suitable length may be used to connect to these jacks.
Refer to the network port connection map
8.2. SFP+ Interfaces
Two SFP+ ports are provided. These ports can be equipped with any suitable transceiver depending
on the application.
Refer to the network port connection map
8.3. Power Button
This button is a momentary tactile switch that powers the Multi-Stack Controller ON and OFF.
Holding this button for several seconds causes a forced shutdown.
8.4. DC Power Connector
The DC Power connector accepts a standard locking male barrel plug (2.5 mm I.D × 5.5mm O.D,
positive center, 5/16"-32 threaded nut).
The DC Power connector provides a nominal 12 V DC to the Multi-Stack Controller, but will tolerate an
input voltage between 11.4 and 12.6 V DC.
The external supply has its negative input connected to earth ground through the
Multi-Stack Controller's chassis.
Document ID: NE-PM-004
Nuvation Energy Multi-Stack Controller - Product Manual
Table 1
and
Figure
7.
Table 1
and
Figure
7.
60
Rev 2.0, 2022-05-18
Curie Update 3
Advertisement
Table of Contents
