Table of Contents
Advertisement
6.5.2. Factory Reset the System
It is highly recommended to only factory reset the unit under guidance from
Nuvation Energy. This action is not reversible and will reset the unit to the same
state as it was shipped from the factory.
To reset the Multi-Stack Controller, click the "Factory Reset" button.
The reset process may take a few minutes, so please wait for it to complete. The
page will automatically refresh once the reset is complete. However, the process will
reset all network settings, so the Multi-Stack Controller may no longer be reachable
without adjusting the computer's network settings.
6.5.3. Rebooting and Powering off the System
To reboot the Multi-Stack Controller, click on the "Reboot" button and wait until the unit has been
rebooted. To power off the Multi-Stack Controller, click on the "Power off" button. Following a shut
down, the power button can be used to restart the Multi-Stack Controller.
The UI will not be functional while the Multi-Stack Controller is rebooting.
6.5.4. Setting the Date, Time, and Timezone
The Timezone and Date/Time are individually configurable.
Setting the Date and Time
1. Click the blue edit-button to the right of the "Time" label.
2. Select the date and time by clicking on the field that is shown.
3. Click "Apply" to save the changes or "Cancel" to discard the changes.
Setting the Timezone
1. Click on the blue edit-button to the right of the "Timezone" label
2. Select the desired timezone from the dropdown list.
3. Click "Apply" to save the changes or "Cancel" to discard the changes.
Document ID: NE-PM-004
Nuvation Energy Multi-Stack Controller - Product Manual
51
Rev 2.0, 2022-05-18
Curie Update 3
Advertisement
Table of Contents
