Table of Contents
Advertisement
4.2. Multi-Stack Controller Electrical Connections
Before making any connections, ensure that power is not applied to the Multi-Stack
Controller.
4.2.1. Getting Started
Before connecting power to the Multi-Stack Controller you need to:
1.
Connect Stack Switchgear communications
2.
Connect external network or system
3.
Verify grounding
Below are images of the external interfaces available on the front and back of the Multi-Stack
Controller.
Figure 5. Multi-Stack Controller external interfaces (front)
Figure 6. Multi-Stack Controller external interfaces (back)
4.2.2. Step 1: Connect Stack Switchgear Communications
Connect the Stack Switchgear units to the Ethernet RJ45 ports labelled 1 to 4 using Cat5e-rated or
higher Ethernet cables of suitable lengths. Refer to the network port connection map
The Stack Switchgear only supports ports at 10/100 Mbps Ethernet. To connect a
Stack Switchgear to port 5 or 6, an Ethernet switch supporting 1 Gpbs and 10/100
Mbps is required.
Document ID: NE-PM-004
Nuvation Energy Multi-Stack Controller - Product Manual
Table 1. Network Port Connection Map
11
Table
1.
Rev 2.0, 2022-05-18
Curie Update 3
Advertisement
Table of Contents
