Aerial GTWY Series Operator's Manual page 15

Setup
1 Position the machine on a firm surface below
the desired work area directly.
2 Connect to the appropriate power source:
Inappropriate power could cause damage.
Connect to a grounded 15A AC power
supply. Use a 12 gauge / 3.3mm 3-wire
grounded extension cord no longer than 50
feet / 13 m. The power light is on.
3 Turn the circuit breaker on .
4 Insert the key and turn to ground control or
platform control as you want.
5 Twist to release the red Emergency Stop
buttons both at the ground and the platform
controls.
6 Install the outriggers and adjust to level the
machine and raise the base casters slightly off
the ground.
7 Be sure all four interlock display lights at the
ground controls are on and all four outriggers
are in firm contact with the ground.
8 Use the bubble level to
make sure the machine is
level.
Note: If adjustment is
necessary, check the
bubble level and interlock display again to
make sure the machine is level and all four
interlock display lights are on.
Emergency Stop
Push in the red Emergency Stop button at the
platform controls or at the ground controls to
stop the up/down function.
Platform Raise and Lower
1 Twist to release the red Emergency Stop
2
buttons to the on positions at the platform
controls and at the ground controls.
2 You could move the platform by push in the
up/down switch at ground control in the
direction of intended travel. (Turn the key
switch to ground control)
3 You can also move the platform by Push in
the control activate button and rotate the
up/down switch at platform control in the
direction of intended travel. (Turn the key
switch to platform control)
4 The operator need to hold the inner guard
rails to avoid trapping or crushing injury.
5 Do not put feet or hands on moving parts to
avoid trapping or crushing injury.
Manual Lowering
1 Activate the manual lowering valve located
at the side of the hydraulic unit.
2 The platform should lower.
GTWY SERIES 13
Operator's Manual