Aerial GTWY Series Operator's Manual page 4

Do not operate an AC powered machine or a
DC battery charger unless using a 3-wire
grounded extension cord connected to a
grounded AC circuit. Do not alter or disable
3-wire grounded plugs.
Tip-over Hazards
Do not raise the platform unless the base is
level, all four outriggers are properly installed
and the leveling jacks firmly contact the floor.
Do not adjust or remove the outriggers while the
platform is occupied or raised.
Do not move the machine while the platform is
raised.
Do not place ladders or scaffolds in the platform
or against any part of this machine. Do not
place or attach overhanging loads to any part of
this machine.
Do not transport tools and materials unless they
are evenly distributed and can be safely
handled by the person in the platform.
Do not raise the platform unless the machine is
level. Do not set the machine up on a surface
where it cannot be leveled using only the
leveling jacks.
Do not cause a horizontal force or side load to
the machine by raising or lowering a fixed or
overhanging load.
Do not operate the machine near drop-offs,
holes, bumps, debris, unstable or slippery
surfaces or other possible hazardous
conditions.
Do not alter or disable machine components
that in any way affect safety and stability.
Do not replace items critical to stability with
items of different weight or specification. Use
only Rees authorized replacement parts.
Do not push the GTWY series from the platform
side of the machine.
When moving the machine with a forklift or
other transport vehicle, the platform should be
fully lowered, the machine should be turned off
and no personnel shall remain in the platform.
Do not use the machine on a moving or mobile
surface or vehicle.
Do not raise the platform when wind speeds
may exceed 28 mph / 12.5 m/s. If wind speeds
exceed 28 mph / 12.5 m/s when platform is
raised, lower the platform and do not continue
to operate the machine.
Do not operate the machine in strong or gusty
winds. Do not increase the surface area of the
platform or the load. Increasing the area
exposed to the wind will decrease machine
stability.
GTWY SERIES 2
Operator's Manual
Safety Rules
Do not push off or pull
toward any object outside
the platform.
Maximum allowable
side force 200N