Remote Control - M2TECH MANUNTA User Manual

EVO DAC 3
DIGITAL-TO-ANALOG CONVERTER
REVISION P – JUNE 2022
RB

4. Remote Control

Figure 3
The Evo DAC 3 comes with a fully-loaded remote control which
allows for setting all of its controls, as well as for controlling other
M2Tech Rockstars series products.
Please note when a command is sent to the Evo DAC 3 the "DAC"
key blinks in green. If any of the other key "AMP", "PHONO" or
"PLAYER" blinks instead, the Evo DAC 3 will not receive the
command. In this case, press the "DAC" key to select the right
commands codes for the Evo DAC 3.
Below is a brief description of the relevant keys for the Evo DAC 3.
Standby key: This allows for putting the Evo DAC 3 in standby
mode (prolonged push) and for awakening it.
DIM: Display dimming.
DAC: Instructs the remote to send commands using the DAC
system code.
VOL+/VOL-: Volume setting.
MUTE: Mute toggle on/off.
PHASE: Phase toggle inverting/non inverting. Please note this
setting is not indicated on the front panel.
IN+/IN-: Input selection.
Player Controls: these buttons are dedicated to the control of an
audio player running on the computer attached to the Evo DAC 3.
The following commands can be sent: Play/pause, stop, next,
track, previous track
13
MANUNTA
BY M2Tech
www.manunta-audio.com
Copyright © 2022, M2Tech Srl