Table of Contents
Advertisement
12
Physical Controls
Power Switch
RX2's with an optional internal battery have a Power Switch to turn the unit On or Off.
RX2's without the internal battery have no power switch. These units are On whenever DC power
is applied.
Note:
The power switch, if present, is located on the side of the RX2 enclosure. When power is present,
flipping the switch to On powers up the RX2. However, if a battery charger is connected, the RX2
remains Off, regardless of switch position.
Flipping the switch to Off powers off the RX2. The RX2 is also powered off if the charger is
connected regardless of switch position.
If the RX2 does not have a power switch, the RX2 is On whenever DC power is present. It is Off
when DC power is not present.
Restart Sequence
There are several ways to restart the RX2.
RX2 Reference Guide
The DC to DC Power Supply contains an On/Off switch. When this switch is set to Off,
power is not supplied to the RX2.
Figure 2-2 Location of the Power Switch
•
The power switch (if present) can be cycled
•
DC power can be removed (note that the DC to DC Power Supply includes an
On/Off switch)
•
The WARMBOOT.EXE utility can be used.
To use WARMBOOT.EXE, an ActiveSync connection must be established
o
and ActiveSync Remote Display must be running.
On the RX2 desktop, click Start | Run, then type warmboot in the
o
textbox and press Enter.
When the power LED begins flashing, this indicates the power on (or
o
reboot) sequence is complete. If any changes to the settings had been saved
previously, they are restored on reboot.
Any RFID tag data retrieved and not saved is lost during a reboot or reset.
o
Physical Controls
E-EQ-RX2RG-B
Advertisement
Table of Contents
