Components; Quick Start; Figure 1 Rx2 Connector Panel; Figure 2 Rx2 Components - LXE RX2 User Manual

Components

Components

Quick Start

Note:
This section's instructions are based on the assumption that your new system is pre-configured
and requires only a power source.
In general, the sequence of events is:
1. Provide a power source for the RX2:
2. Flip the power switch to On (Battery powered units only).
Note:
E-EQ-RX2OGWW-B
2
1

Figure 1 RX2 Connector Panel

1
2

Figure 2 RX2 Components

The RX2 is assembled with an optional internal battery pack (if ordered) and radio card
installed before shipment.
•
Connect an external power source to the unit (if required).
-or-
•
Use the optional internal battery pack (the internal battery pack, if ordered, must be
fully charged before use).
Do not connect a tethered scanner cable to a USB-C labeled port. This port cannot
power a tethered scanner.
1.
3
4
2.
3.
4.
1.
2.
3
3.
4.
4
Power Switch (Battery
Powered Units Only)
Input Power/Battery
Charger Connector
USB Client Connector
COM3/RS232
Connector
RX2 Computer
Fork Truck Mounting
Bracket
Power LED
Antenna Enclosure
RX2 User's Guide
3