CyberPower CPS625AVR User Manual page 17

With usb interface

Table of Contents

FCC Notice

This equipment has been tested and found to comply with the limits for a Class B Digital Device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in residential installation. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful interfer-

ence to radio or television reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more of the following measures:

(1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment

and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected. (4) Consult the dealer or an experienced radio/TV technician for help. Any

special accessories needed for compliance must be specified in the instruction.

CAUTION: A shielded-type power cord is required in order to meet FCC emission limits and also to

prevent interference to the nearby radio and television reception. It is essential that only the sup-

plied power cord be used. Use only shielded cables to connect I/O devices to this equipment.

CAUTION: Any changes or modifications not expressly approved by the guarantee of this device

could void the user's authority to operate the equipmen

For more information, contact us at:

CyberPower Systems (USA), Inc.

5555 12

Avenue East

Suite 110

Shakopee, MN 55379

Tel: (952) 403-9500

Fax: (952) 403-0009

Email:

sales@cyberpowersystems.com

Web:

www.cyberpowersystems.com

PowerPanel™ is a trademark of CyberPower Systems (USA), Inc.

REV.625001

Table of Contents