Related Manuals for CyberPower CPS725SL
Summary of Contents for CyberPower CPS725SL
- Page 1 User’s Manual for: CPS725SL with USB Interface and PowerPanel™ Software ADDITIONAL INSTALLATION TIPS CAN BE FOUND AT: www.cyberpowersystems.com/FAQs.htm...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Thank you for purchasing a CyberPower Systems Product. To enjoy all the features and benefits of this Uninterruptible Power System (UPS), please read and follow all installa- tion and operation instructions completely. This UPS is designed to provide guaranteed power protection for connected electronic equipment. - Page 3 (Please see DO NOT USE FOR MEDICAL OR LIFE SUPPORT EQUIPMENT! CyberPower Systems does not sell prod- ucts for life support or medical applications. DO NOT use in any circumstance that would affect operation or safety of any life support equipment or with any medical applica- tions or patient care.
-
Page 4: Hardware Installation Guide
Insure that the equipment plugged into the three battery power-supplied outlets does not exceed the UPS unit’s rated capacity(725VA/400W for CPS725SL). If rated unit capacities are exceeded, an overload condition may oc- cur and cause the UPS unit to shut down and the circuit breaker to trip. -
Page 5: Installation Guide
UPS and an open serial port on the back of the computer. PowerPanel™ disk into the floppy drive. to serial port on the UPS and an open serial port on the back of the computer. CPS725SL (Note: You... - Page 6 10. Click on Start, point to Settings, and then click Control Panel. 11. Double-click on Add / Remove Programs. 12. Click the Install Button, and follow the on-screen instructions. 13. When the installation is completed, remove the floppy disk. For Windows XP (Home and Professional) 1.
- Page 7 Please note: This service must be stopped in order to use the PowerPanel™ software. To stop the service, remove the checkmark from Uninterruptible Power Supply is installed on. Click OK. Acknowledge the message that the UPS is in an unknown state and exit to the desktop.
-
Page 8: Battery Replacement Instructions
Please note: This service must be stopped in order to run PowerPanel™. To disable the service, set the Manufac- turer to None. Please note: You must be logged on as an administrator or a member of the administrator’s group to make these changes. -
Page 9: Led Indicators
AC outlet such as bad ground, miss ground, or reversed wiring. None User is advised to disconnect all electrical equipment from the outlet and have an electri- cian check the outlet to insure proper wiring. CPS725SL... -
Page 10: Trouble Shooting Guide
Wait 10 seconds, reset the circuit breaker by depressing the button, and then turn the UPS on. Recharge the battery by leaving the UPS plugged in. Contact CyberPower Systems about replacement batteries at tech@cyberpowersystems.com Turn the UPS off. Wait 10 seconds and then turn the UPS on. -
Page 11: Specifications
EXPECTED RUNTIME IN MINUTES Desktop PC with LCD Monitor Desktop PC with 15” Monitor Desktop PC with 17” Monitor Desktop PC with 21” Monitor Guaranteed Uninterruptible Power System CPS725SL 725VA(400W) 100V to 140V 57 Hz to 63 Hz 120Vac ± 5% 4ms Typical... -
Page 12: Warranty
Limited Warranty and Power Control Guarantee In purchasing CPS725SL in the United States or Canada, the original end user receives a Limited Warranty and CyberPower's Power Control Guarantee from Cyber Power Systems (USA), Inc. (for ease of reading, referred to as "CyberPower"). - Page 13 Limited Warranty, applies only to Connected Equipment, and all such Liability is limited to the Agreed Damage Amount. Making a Power Control Guarantee Claim. To make a Warranty claim for damage to Connected Equipment under the Power Control Guarantee, you must do the following: Guaranteed Uninterruptible Power System POWER CONTROL GUARANTEE CPS725SL...
- Page 14 Power), or (c) the lowest price the same or similar items can be purchased for in the United States; or 2. The aggregate ceiling amount for all Connected Equipment: CyberPower CPS725SL -$150,000.00 3. The amount(s) of all payment you have or are entitled to receive from insurance, other warranties, extended warranties, or from other sources or persons for the Connected Equipment or damage to such equipment so that CyberPower’s maximum liability shall be reduced to reflect all such other payments or sources of recovery...
- Page 15 The Limited Warranty and the Power Control Guarantee are governed by the laws of the United States and the State of Minnesota, without reference to conflict of law principles. The application of the United Nations Convention of Contracts for the International Sale of Goods is expressly excluded. Guaranteed Uninterruptible Power System CPS725SL...
- Page 16 Contact Information: CyberPower's address is 5555 12th Ave East, Suite 110, Shakopee, MN 55379 and its phone number is (952) 403-9500 or (877) 297-6937 (toll free). CyberPower is the warrantor under this Limited Warranty. You may also contact CyberPower on the Internet at www.cyberpowersystems.com.
- Page 17 Tel: (952) 403-9500 Fax: (952) 403-0009 Toll-Free: (877)-297-6937 Email: sales@cyberpowersystems.com Web: www.cyberpowersystems.com Entire contents copyright ©2003 CyberPower Systems, Inc. All rights reserved. Reproduction in whole or in part without permission is prohibited. PowerPanel™ is a trademark of CyberPower Systems (USA), Inc.