Summit Wireless Security; No Security; Figure 4-8 Summit Profile With No Security - LXE MX3 Reference Manual

140

Summit Wireless Security

Use the instructions in this section to complete the entries on the Config tab according to the type
of wireless security used by your network. The instructions that follow are the minimum required
to successfully connect to a network. Your system may require more parameters than are listed in
these instructions. Please see your System Administrator for complete information about your
network and its wireless security requirements.
Note:
Default profile
Switching
profiles
Adding/changing
profiles

No Security

Start the Summit Utility by tapping the Summit Client icon.
Tap the Admin Login button on the Main panel. Enter the Administrator password and tap OK.
Tap the Config tab.
Enter the SSID of the Access Point assigned to this profile.
Set Auth Type to Open.
Set EAP Type to None.
Set Encryption to None.
Tap the Commit button
Perform a warm reset to connect using the new profile configuration.
2
LXE recommends performing a soft reset or Suspend/Resume function each time the Commit button is
tapped.
MX3-RFID Reference Guide
It is important that all dates are correct on CE computers when using any type of
certificate. Certificates are date sensitive and if the date is not correct authentication will
fail.
LXE recommends editing the Default profile instead of creating new
profiles. Important: Perform a soft reset (or Suspend/Resume) after
changing parameters to save the changed parameters in the registry.
Successfully connecting after switching from one profile to another may
take up to 30 seconds from the moment the "Is not authenticated" message is
displayed.
LXE recommends performing a Warmboot function (or Suspend/Resume)
after tapping the Commit button.

Figure 4-8 Summit Profile with No Security

2
to save the new profile configuration.
Summit Client Configuration
E-EQ-MX3RFIDRG-A