Power Connection; Switching On/Off - Bush DLED50UHDHDRSB Instruction Manual

Getting to know your TV
You'll be up and running in no time

Power Connection

IMPORTANT: The TV set is designed to operate on a
220-240V AC, 50 Hz supply. After unpacking, allow the
TV set to reach the ambient room temperature before
you connect the set to the mains. Plug the power cord
to the mains socket outlet.

Switching On/Off

To Switch the TV On
Connect the power cord to a power source such as a
wall socket (220-240V AC, 50 Hz).
To switch on the TV from standby mode either:
• Press the Standby button, Programme +/-, a numeric
button, Guide button, Netflix button or Freeview Play
button on the remote control.
• Press the control button on the TV.
To Switch the TV Off
• Press the Standby button on the remote control.
• Press the control button on the TV, the function options
menu will be displayed. The focus will be on the Standby
option. Press and hold the button for about 2 seconds
to activate this option. The icon colour of the option will
change. The TV will turn off when the button is released.
To power down the TV completely, unplug the power
cord from the mains socket.
Note: When the TV is switched into standby mode, the
standby LED can blink to indicate that features such as
Standby Mode Search, Over Air Download or Timer is
active. The LED can also blink when you switch on the
TV from standby mode.
If you require any technical guidance or find that your TV is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
or online at www.bush-support.co.uk If you still require further assistance, call one of our experts on 0345 604 0105, a Bush enquiry line.
Getting to know your TV
12