Craftsman CX Series Operator's Manual page 8

5. Re-tighten the hardware securing the chute crank bracket.
6. Check that the chute cables are properly routed through the cable guide on
top of engine shroud. See Figure 6.
ASSEMBLY
Figure 4
Chute Crank Bracket
Figure 5
Figure 6
Set-Up
Shear Pins
A pair of replacement auger shear pins and bow tie cotter pins have been included with your
snow thrower. They are stored in the holes provided in the plastic dash panel as seen in
Figure 7. For information regarding replacing the shear pins, see Replacing Shear Pins in the
Operation section of this manual.
Chute Clean-Out Tool
The chute clean-out tool is fastened to the top of the auger housing with a
mounting clip and a cable tie at the factory. Cut the cable tie before operating the
snow thrower. See Figure 8.
8
Figure 7
Clean-out Tool
Figure 8