Table of Contents
Advertisement
Optional equipment
Orange indicator: This light shows that the
1
access control unit is ON. The keypad always
has power regardless of the emergency-stop,
off/base/platform key switch, or main power
disconnect position.
Green/red indicator: A green light shows that
2
the access control unit is in operation. A red light
that flashes shows that the keypad received a
cancel input.
Operation
To operate the MEWP , the light and all of these power
connections must be ON before the set time expires.
This set time is the time that the MEWP owner sets for
the access control operation.
The green light on the keypad of the access
▪
control unit.
The main power disconnect switch.
▪
The emergency-stop button on the base control
▪
console.
The off/base/platform key switch.
▪
You can also set these power connections to ON
before you start the access control unit.
To operate the access control unit, use the PIN code
or Smart ID card.
With the Keypad:
NOTE
This touch-sensitive keypad beeps to identify a
correct input.
1. Enter the PIN code.
2. Press the green checkmark to confirm.
Result: The green light identifies an approved
▪
ID. Start the operation.
NOTE
If you push an incorrect button when you enter
the PIN code, push the Cancel button to start
again.
With the Smart ID Card:
1. Put the card in front of the reader.
2. A beep identifies that the reader read the
card.
Result: The green light identifies an
▪
approved ID. Start the operation.
SJ40 T+, SJ45 T+
IMPORTANT
If the set time of the access control unit expires,
enter the PIN code or tap the Smart ID card again.
If there is a failure of the access control activation,
speak to the MEWP owner.
IMPORTANT
The access control unit will not operate if these
power connections are not ON in the set time, or if
the operator disconnects them:
The main power disconnect switch
▪
The emergency-stop button on the base
▪
control console
The off/base/platform key switch.
▪
IMPORTANT
To start the access control unit, enter the PIN
code or tap the Smart ID card. These power
connections must be in the ON position in the set
time:
The main power disconnect switch
▪
The emergency-stop button on the base
▪
control console
The off/base/platform key switch.
▪
Function Tests
Do the function tests as specified in
When you do the function tests, make sure that the
green light on the keypad is ON. This light confirms
that the access control unit is in operation. Do the
function tests for these power connections in the set
time:
The main power disconnect switch
▪
The emergency-stop button on the base control
▪
console
The off/base/platform key switch.
▪
Section 3 – Familiarization
Section
4.3.
238261AAA
37
Advertisement
Table of Contents
