Nexcom NEX 812 User Manual page 39

Chapter 3: BIOS Setup
Trusted Computing
This section is used to configure Trusted Platform Module (TPM) settings.
Aptio Setup Utility - Copyright (C) 2017 American Megatrends, Inc.
Advanced
Configuration
Security Device Support [Enable]
NO Security Device Found
Version 2.18.1263. Copyright (C) 2017 American Megatrends, Inc.
Security Device Support
Enables or disables BIOS support for security device. O.S will not show
Security Device. TCG EFI protocol and INT1A interface will not be available.
Copyright © 2020 NEXCOM International Co., Ltd. All Rights Reserved.
SATA Configuration
This section displays information of the SATA drives.
Enables or Disables BIOS
support for security device.
O.S. will not show Security
Device. TCG EFI protocol and
INT1A interface will not be
available.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
SATA Controller(s)
Enables or disables SATA device.
SATA Mode Selection
Configures the SATA controller as AHCI or RAID mode.
Port 1 to Port 6
Enables or disables SATA port 1, port 2, port 3, port 4, port 5 or port 6.
Hot Plug
Enables or disables hot plugging feature on SATA port 1, port 2, port 3,
port 4, port 5 or port 6.
25
Aptio Setup Utility - Copyright (C) 2017 American Megatrends, Inc.
Advanced
SATA And RST Configuration
SATA Controller(s) [Enabled]
SATA Mode Selection [AHCI]
Serial ATA Port 1 Empty
Port 1 [Enabled]
Hot Plug [Disabled]
Serial ATA Port 2 Empty
Port 2 [Enabled]
Hot Plug [Disabled]
Serial ATA Port 3 Empty
Port 3 [Enabled]
Hot Plug [Disabled]
Serial ATA Port 4 Empty
Port 4 [Enabled]
Hot Plug [Disabled]
Serial ATA Port 5 Empty
Port 5 [Enabled]
Hot Plug [Disabled]
Serial ATA Port 6 Empty
Port 6 [Enabled]
Hot Plug [Disabled]
Version 2.18.1263. Copyright (C) 2017 American Megatrends, Inc.
Enable/Disable SATA Device.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
NEX 812 User Manual