Eoi Operation - Toshiba G7 Operation Manual

Down Key — Decreases the value of the selected parameter or scrolls down the menu listing (continues
during press and hold).
Rotary Encoder — Functions as the Up key, the Down key, and the Enter key. Turn the Rotary
Encoder either clockwise or counterclockwise to perform the Up or Down key functions. Press the
Rotary Encoder to perform the Enter function. Simultaneously pressing and turning the Rotary
Encoder performs a user-defined function (see Program ⇒ EOI Option Setup ⇒ Preferences ⇒
Encoder Action).
MON/PRG — The MON/PRG key provides a means to access the three root menus. Pressing the MON/
PRG key repeatedly loops the system through the three root menus (see
Figure 16. The G7 Electronic Operator Interface.
Local/Remote
Key (LED)
Monitor/Program
Key
Run Key
(LED)

EOI Operation

The EOI is the primary input/output device for the user. The EOI may be used to monitor system
functions, input data into the system, or perform diagnostics.
Note: The Up/Down arrow keys and the Enter key may be used to perform the functions of the
Rotary Encoder. The Rotary Encoder will be used in this explanation and throughout
this manual for the Up, Down, and Enter key functions.
The software used with the G7 is menu driven; thus, making it a select and click environment. The
operating parameters of a motor may be selected and viewed or changed using the EOI.
To change a parameter setting, go to the Program mode by pressing the MON/ PRG key until the
Program menu is displayed. Turn the Rotary Encoder until the desired parameter group is within the
cursor block. Press the Rotary Encoder (repeat if there is a submenu).
The selection will take on the reverse video format (dark background/light text). Turn the Rotary
Encoder to change the value of the parameter. Press the Esc key while the display is in the reverse video
mode to exit the menu without saving the change or press the Rotary Encoder to accept the new setting.
Repeated Esc key entries takes the menu back one level each time the Esc key is pressed until the root
level is reached. After reaching the root level, continued Esc entries will toggle the system to and from
the Frequency Command mode and the Panel menu (the Panel menu is discussed on
be accessed via Program ⇒ Direct Access Parameter ⇒ F008).
26
Pressed
Figure 19 on pg. 32).
LCD Display
Enter Key
Up/Down Arrow
Keys
Rotary Encoder
Esc Key
|
Stop Reset Key
page 33 and may
G7 ASD Operation Manual