Toshiba G7 Operation Manual page 134

F440
Power Running Torque Limit #1
Program ⇒ Torque Setting Parameters ⇒ Torque Limit Settings
This parameter determines the source of the control signal for the positive
torque setting. If Setting is selected, the value set at
parameter.
Settings:
VI/II
RR
RX
RX2
Setting
Driving Torque Limit #1
Program ⇒ Torque Setting Parameters ⇒ Manual Torque Limit
Settings
This parameter provides a value to be used as the Power Running Torque
Limit #1 setting if Setting is selected at F440.
Regeneration Torque Limit #1
Program ⇒ Torque Setting Parameters ⇒ Torque Limit Settings
This parameter determines the source of the Regenerative Torque Limit
control signal. If Setting is selected, the value set at
parameter.
Settings:
VI/II
RR
RX
RX2
Setting
Regeneration Torque Limit Setting #1
Program ⇒ Torque Setting Parameters ⇒ Torque Limit Settings ⇒
Manual Settings
This parameter provides a value to be used as the Regeneration Torque Limit
#1 if Setting is selected at F442.
126
F441 is used for this
F443 is used for this
Direct Access Number — F440
Parameter Type — Selection List
Factory Default — Setting
Changeable During Run — Yes
Direct Access Number — F441
Parameter Type — Numerical
Factory Default — 250.0
Changeable During Run — Yes
Minimum — 0.0
Maximum — 250.0
Units — %
Direct Access Number — F442
Parameter Type — Selection List
Factory Default — Setting
Changeable During Run — Yes
Direct Access Number — F443
Parameter Type — Numerical
Factory Default — 250.0
Changeable During Run — Yes
Minimum — 0.0
Maximum — 250.0
Units — %
G7 ASD Operation Manual
F443