Electronic Operator Interface; Eoi Operation; Battery Backup - Toshiba H9 Quick Start Manual

Electronic Operator Interface

The H9 ASD Electronic Operator Interface (EOI) is comprised of an LED screen, an LCD screen, two
LEDs, a rotary encoder, and five keys. These items are shown and described on

EOI Operation

The EOI is the primary input/output device for the user. The EOI may be used to monitor system
functions, input data into the system, perform diagnostics, and view performance data (e.g., motor
frequency, bus voltage, torque, etc.).
The software used with the H9 ASD is menu driven; thus, making it a select and click environment. The
operating parameters of a motor may be selected and viewed or changed using the EOI (or via
communications).

Battery Backup

The EOI is equipped with a battery backup system. The function of the backup system is to retain the EOI
SRAM programming in the event of a power outage, or if an EOI removal and installation from one
system to another is required without the loss of programming.
Listed below are the items retained by the battery backup system:
Trip History,
EOI Contrast,
Real-time Clock Information,
Monitor Items,
Password/Lockout Information,
Alarm Information,
Main Monitor Items,
Prohibited Items, and
the Save User Settings Information (Parameter settings if saved by the user).
The battery backup system must be activated by the installer or maintenance personnel to use the backup
function.
To activate the battery backup system, remove the Phillips screw from the front of the LED/LCD display
unit. Remove the LED/LCD display unit from the ASD. From the circuit side of the display unit, remove
the jumper at J1, pins 2 and 3. Place the jumper at J1, pins 1 and 2.
The expected battery life cycle is four and a half years.
Note: The Battery backup system does not supply power to the LED/LCD display.
LED/LCD Screen Installation Note
When installing the LED/LCD display unit of the EOI, ensure that the left side of the display is inserted
first with the top and bottom catches (see Phillips screws at underside of display) securely in place. This
ensures the proper alignment and electrical connection of the CNX connector of the LED/LCD display
unit PCB. Gently hold the display in place while securing the Phillips mounting screw.
If improperly seated, the periphery of the LED/LCD display unit will not be flush with the EOI surface
and the unit will not function properly.
24
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
pg. 26.
H9 ASD Quick Start Guide