norbar T-Box 43236 Operator's Manual page 33

22. Select the 'Uncertainty'
Note: Uncertainties are greyed out for 'Other' Tool Type. They are also not used for ISO 6789-1:2017
Declarations of Conformance tests so can be left blank if not performing ISO 6789-2:2017 Certificates of
Calibration on this model of tool.
23. Enter Resolution uncertainty value for this model of tool.
This is a torque value in the same units as the tool.
This is greyed out and forced to a value of zero for Type II, Class B, C, E and F tools
24. Enter Reproducibility uncertainty value for this model of tool if known, or use Test Data (see below).
This is a torque value in the same units as the tool.
This is greyed out and forced to a value of zero for Type II, Class B, C, E and F tools
Press the Test Data button to view/use reproducibility uncertainty test data for this model of tool.
25. Enter Loading Point uncertainty value for this model of tool if known, or use Test Data (see below).
This is a torque value in the same units as the tool.
This is greyed out and forced to a value of zero for Type I, Class D and E and Type II, Class D, E and F
tools.
Press the Test Data button to view/use loading point uncertainty test data for this model of tool.
26. Enter Output Drive uncertainty value for this model of tool if known, or use Test Data (see below).
This is a torque value in the same units as the tool.
This should be set to zero if the output drive of the tool doesn't rotate.
Press the Test Data button to view/use output drive uncertainty test data for this model of tool.
27. Enter Interface uncertainty value for this model of tool if known, or use Test Data (see below).
This is a torque value in the same units as the tool.
This should be set to zero if no interface (adaptor) is used between the output drive of the tool and the
calibration system.
Press the Test Data button to view/use interface uncertainty test data for this model of tool.
28. Press 'OK' button to save Tool Template.
31