Thermistors / Drain Pump / Float Switch
4. Thermistors / Drain Pump / Float Switch
Warning
Be sure to wait for 10 minutes or more after turning off all power supplies before
Step
1. Release the harnesses.
1
Disconnect the
connectors.
2
Cut the clamp.
3
Pass the relay harness
for drain pump through
the hole to the rear side
of the electrical box.
10
disassembling work.
Procedure
[X25A]
[X18A]
[X16A]
[X17A]
[X15A]
Clamp
Relay harness for drain pump
Relay connector
Points
Open the electrical box
cover beforehand.
[X15A]: float switch (white)
[X16A]: suction air thermistor
(R1T) (white)
[X17A]: middle thermistor (R3T)
(orange)
[X18A]: liquid pipe thermistor
(R2T) (red)
[X25A]: drain pump
(R25881)
(R25882)
Some models do not have
the relay harness for drain
pump.
You may disconnect the
relay connector to pass the
harness easily through the
hole.
(R25883)
Removal Procedure
Si071951E