System Configuration - Omron NT620S Operation Manual

System Configuration

1-3 System Configuration
Reference
8
This section gives the basic configuration of a system which uses an
NT620S/620C. Use an RS-232C cable to connect to a PC. Refer to the manual
for individual device for information on the equipment other than the
NT620S/620C in the system.
For details on setting the method and conditions for communication between the
NT620S/NT620C and the host, refer to Section 3-5 "Setting the Conditions of
Communications with the PC by Using the Memory Switches" (page 69). It is not
possible to connect the personal computer used to run the support software and
the host at the same time (when using an RS-232C cable).
Representative optional devices available for use with NT620S/NT620C are
listed below.
Replacement backlight
Anti-glare sheet
Chemical-resistant cover
Replacement battery
Section
NT620C-CFL01 (for NT620C)
NT600M-KBA04 (for NT620S)
NT620C-KBA04 (for NT620C)
NT600S-KBA01 (for NT620S)
NT620C-KBA01 (for NT620C)
C500-BAT08
1-3