Operation Modes And The System Menu - Omron NT620S Operation Manual

Operation Modes and the System Menu

3-2-1 Changing the System Settings etc.
Procedure 1. Turn ON the power to the NT620S/620C.
3-3 Operation Modes and the System Menu
3-3-1 System Menu and the Operation Modes
The NT620S/620C runs
in this state. Controls
from the PC are enabled
and various indications
and I/O operations are
made.
When system settings
and screen data
registration have been
completed
Power ON
Follow the procedure below to change the system settings or screen data con-
tents.
The NT620S/620C will enter the RUN mode and the start-up screen will be
displayed. The start-up screen varies according to registered screen data.
2. Press appropriate touch switches to display the System Menu, and change
system settings. For the method for calling the System Menu, refer to the
"Operations with the System Menu" (page 61).
If no system program is installed or the system program has been destroyed, the
system program must be installed. For the installation method, refer to 2-4
"Installing the System Program" (page 30).
If the NT620S/620C has failed to start up normally; an error message is dis-
played or no screen is displayed, memory needs to be initialized.
For the memory initializing procedure, refer to Section 3-4 "Initializing Memory"
(page 63).
The NT620S/620C operates in either "RUN", or "Transmit" mode. The operation
modes can be switched by using the System Menu.
Select an operation mode by pressing the corresponding touch switch in the Sys-
tem Menu. The operation modes with respect to the System Menu are related to
each other as shown below.
For the operations with the System Menu, refer to the "Operations with the Sys-
tem Menu" (page 61).
RUN Mode
[ SYSTEM MENU ]
Quit
Transmit Mode
MaintenanceMode
Expansion Mode
Transmit Mode
To change system
Screen data and other
settings or screen
data are transmitted
data contents
between the NT620S/
620C and a support tool.
Maintenance Mode
The NT620S/620C
maintenance operations
such as memory
initialize, setting check
and I/O check are
executed.
Section 3-3
59