Removing the air baffle
CAUTION:
For proper cooling, do not operate the server without the access panel, baffles, expansion slot covers or
blanks installed. If the server supports hot-plug components, minimize the amount of time the access
panel is open.
Procedure
1. Power down the server.
2. Disconnect the power cord from the power source and the server.
3. Remove the bezel.
4. Place the server on its side with the access panel facing up.
5. Remove the access panel.
6. Remove the air baffle.
Installing the air baffle
Procedure
1.
Power down the server.
2.
Disconnect the power cord from the power source and the server.
3.
Remove the bezel.
4.
Place the server on its side with the access panel facing up.
5.
Remove the access panel.
6.
Insert the tabs on the baffle into the slots on the rear chassis.
7.
Press the front end of the baffle into the chassis.
Removing the air baffle
21