Yealink W70B User Manual page 62

2. Select Options > Conference.
On the CP930W, select Conf..
On the DD phone/CP935W, select Conference.
The active call is placed on hold.
3. Dial the second party's number.
4. When the second party answers the call, select or Conference to add the second party to the
conference.
On the CP935W, select Conference or
5. Select Conf. or Conference to place a new call.
The conference call is placed on hold.
6. Enter the number of the new party, and then press the OK key.
7. When the new party answers the call, select Conf. to add the new party to the conference.
On the CP935W, select Conference or
8. Repeat steps 5 to 7 until you add all parties.
Note: The procedures for setting up a network conference call on specific servers may be
different. Contact your system administrator for more information.
Inviting another Party into an Active Conference Call
Any party in the conference call can invite other party into an active conference call.
Procedure
1. Select New Call.
On the CP930W/DD phone, select Conf. or Hold > New Call.
On the CP935W, select Conference or
2. Enter the desired number and dial out.
3. When the new party answers the call, select Options > Conference.
On the CP930W/DD phone, select Conf..
On the CP935W, select Conference or
The new party is joined the conference call.
Holding/Resuming a Conference Call
Any party in the conference call can place himself/herself on hold, but other parties can continue the
conference call normally.
About this task
Note: The conference call will only be held when all parties in the conference call place themselves
on hold.
Procedure
1. Select Options > Hold.
On the CP930W/DD phone/CP935W, select Hold.
2. Select Resume to resume the held conference call.
> Merge Calls.
> Merge Calls.
> New Call.
> Merge Calls.
| Call Features | 62