Honda EU30i Manual page 88

CARBURETOR DISASSEMBLY/
ASSEMBLY
Gasoline is highly flammable and explosive. You
can be burned or seriously injured when handling
fuel.
• Keep heat, sparks and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
To prevent serious eye injury, always wear safety
goggles or other eye protection when using com-
pressed air.
PILOT JET
ASSEMBLY:
Before installing, clean
thoroughly with low pressure
compressed air.
Lightly lubricate the O-ring to
ensure easy installation into
the carburetor body.
THROTTLE STOP SCREW
PILOT SCREW
LIMITER CAP
MAIN NOZZLE
ASSEMBLY:
Before installing, clean
thoroughly with low
pressure compressed
air.
MAIN JET
ASSEMBLY:
Before installing, clean
thoroughly with low
pressure compressed
air.
MAIN JET NUMBER: #78
O-RING
O-RING
DRAIN SCREW
FUEL STRAINER SCREEN
ASSEMBLY:
O-RING
Before installing, clean
the screen and check for
damage.
Install the screen as far
as it goes.
SEALING
WASHER
SET BOLT
6.9 N·m (0.7 kgf·m,
5 lbf.ft)
FUEL SYSTEM
FLOAT PIN
FLOAT VALVE
FLOAT VALVE SPRING
FLOAT
ASSEMBLY:
Check for smooth movement
after installation.
FLOAT CHAMBER
ASSEMBLY:
Install the float chamber to the
carburetor body at an angle as
shown.
6-15