Crankshaft Bearing Replacement (Crankcase Cover Side) - Honda EU30i Manual

CYLINDER BLOCK
CRANKSHAFT BEARING
REPLACEMENT (CRANKCASE COVER
SIDE)
LOCATION
CRANKSHAFT BEARING (6205)
CRANKSHAFT BEARING (6205)
Remove the crankcase cover (page 15-3).
Pull out the radial ball bearing (1) using the special
tools.
TOOLS:
Bearing remover shaft set,
25 (2)
Sliding hammer weight (3)
Apply oil to the circumference of a new bearing (1).
Drive the radial ball bearing until it is fully seated on the
end using the special tools.
TOOLS:
Driver handle, 15x135L (2)
Bearing driver attachment, 52x55
(3)
Pilot, 25 (4)
15-12
07936-ZV10100
07741-0010201
(2)
(1)
07749-0010000
07746-0010400
07746-0040600
(2)
(Circumference)
(3)
(1)
(3)
(4)