Honda EU30i Manual page 154

FAN COVER/FAN COVER GUIDE
REMOVAL/INSTALLATION
Remove the following parts:
– Muffler (page 12-2)
– Generator/engine (page 13-2)
FAN COVER BRACKET
INSTALLATION:
Install the fan cover bracket, aligning the
cutout with the tab of the fan cover guide
assembly.
WASHER
COOLING FAN
RECOIL STARTER
PULLEY
BOLT (6 x 20 mm) (2)
FAN COVER
FLANGE NUT (6 mm)
8.3 N·m (0.85 kgf·m, 6.1 lbf·ft)
CUTOUT
TAB
COLLAR (2)
BOLT (6 x 23 mm) (2)
GENERATOR/ENGINE REMOVAL/INSTALLATION
FAN COVER GUIDE ASSEMBLY
REMOVAL:
Remove the rubber grommet of the stator.
INSTALLATION:
Install the fan cover guide assembly,
aligning the cutout with the groove of the
rubber grommet.
INSTALLATION:
Install the fan cover guide assembly,
aligning the end with the groove of the
upper shroud.
GROOVE
CUTOUT
GROOVE
BOLT (6 x 30 mm) (2)
BREATHER TUBE
BOLT (6 x 20 mm) (3)
13-3