Table of Contents
Advertisement
Configuration with REST Commands
Figure 9. Connect your device to internet
1.
Insert a cellular SIM card in the Bolt LTE SIM card holder.
NOTE
Ensure that the SIM card contact surface is facing towards the
Ethernet port.
2.
Connect the Bolt LTE to a power supply and to Functional Earth (FE).
See
Connect to Power and Ethernet (page 12)
3.
To verify the connection status, check the Bolt LTE RJ45 LED indicators.
See
LED Status Indication (page 24)
4.
Connect an Ethernet cable between the Bolt LTE and the device to be connected to
the internet.
5.
Verify that the device is connected to the internet.
5.5. Configuration with REST Commands
How To Use REST Commands
For information about the supported REST commands and how to use them, refer to the
REST Commands Reference Guide at www.anybus.com/support.
SP2868 Version 1.2
®
Anybus
Wireless Bolt LTE
Page 21 of 28
™
Advertisement
Table of Contents
Related Manuals for HMS Networks Anybus Wireless Bolt LTE
Related Products for HMS Networks Anybus Wireless Bolt LTE
- HMS Networks Anybus Communicator ABC4021
- HMS Networks Anybus Wireless Bridge II CAN AWB3006
- HMS Networks Anybus Wireless Bridge II Serial AWB3015-B
- HMS Networks Anybus North ABC3213-A
- HMS Networks Anybus Communicator ABC3261-A
- HMS Networks Anybus Wireless Bolt Serial AWB2010-B
- HMS Networks Anybus Wireless Bolt LTE AWB1502-B
- HMS Networks AWB6000-A
Need help?
Do you have a question about the Anybus Wireless Bolt LTE and is the answer not in the manual?
Questions and answers