Sanyo ECO-i AHX0752 Technical Data Manual page 75

2. Wireless Remote Controller
2-15. Wiring the Separate Receiver Unit
* Use wires that are AWG#20 to AWG#14 in diameter.
* The wiring length must not exceed 1320 ft.
<Flush Mounting>
Connection diagram
Wire of receiver unit
Provided
(field supply)
wire joint
(WHT 2)
Power wire from
receiver unit
Wire joint
CE-1 (provided)
<Exposed Mounting>
Connection diagram
Use the remote controller cord (optional) for wiring the
separate receiver unit.
1. For the methods used to install the remote controller cord,
refer to "For fl ush mounting into a wall, install the sepa-
rate receiver unit in a metal switch box (fi eld supply) that
has been recessed into the wall in advance" on P. 3-17.
2. When using the remote controller cord (optional), refer to
the instruction manual that came with the cord.
Check the terminal number on the indoor unit before wir-
ing the remote controller and be sure not to wire incor-
rectly. (The unit will be damaged if high voltage, such as
200 VAC, is applied to it.)
Indoor unit
1
remote controller
2
terminal board
1. Strip the insulation to approximately 35/64"
from the ends of the wires to be connected.
2. Twist together the 2 wires and create a
crimp connection at the wire joint.
3. If a special crimping tool is not used, or if
the connection is soldered, insulate the
wires using insulation tape.
Indoor unit
1
remote controller
2
terminal board
Remote controller cord (optional)
Control of W-3WAY ECO-i SYSTEM
WHT
1
2
BLK
Power wire from
Wire of
receiver receiver unit
unit (field
Connector
supply)
WHT
1
Separate
receiver unit
BLK 2
3-21
Separate
receiver unit
1
2
3
4
5
6
7
8