Vega B63-48 Operating Instructions Manual page 10

5 Connecting to power supply
10
10. Push signal cables and screen through the cable gland and con-
nect according to chapter "Wiring plan" to the terminals
11. Check all cable connections, especially the ground connection, to
make sure they are tightened sufficiently
12. Insert terminal block into its position by using the pliers. A me-
chanical coding ensures the correct position
13. Screw cable gland into the thread of B63-48, B63-32, tighten
compression nut. The seal ring must completely encircle the
cable
Fig. 2: Overvoltage protection B63-48, B63-32 after installation and connection
14. Screw the housing cover back on
The electrical connection is hence finished.
Display
I ² C
1 2 5 6 7 8
Overvoltage arresters • B63-48, B63-32