Power Connection; Figure 2-1. Power Connection - ADTRAN T1 ESF CSU ACE User Manual

Chapter 2. Installation

POWER CONNECTION

The T1 ESF CSU ACE can be powered in one of two ways:
•
•
Both have a three-pin receptacle that plugs into the power
connection on the bottom right edge of the T1 ESF CSU ACE. Once
power has been applied to the unit, the power LED turns on. See
Figure 2-1 for an illustration of the cable installation. Refer to Figure
A-1 on page A-1 for power connection wiring.
With the T1 ESF CSU ACE face up, plug the cable in with the plug ori-
ented as shown in Figure 2-1.
2-2
A wall-mount -48 VDC power supply (supplied with the unit)
A power cable for use with an on-site -48 VDC power supply
T1 ESF CSU ACE User Manual

Figure 2-1. Power Connection

61203025L1-1