Stanley EX5200 Deployment Manual page 11

(#3) Chain IN: RJ-45 connector. This connector is used for receiving data from
chained Exciters. The Chain IN port is also used to set the Exciter IP via the
Exciter Manager Application using a special 10-pin RJ45 to DB9 serial cable
(AeroScout SKU EXM-1000, or part of the Hardware Management kit).
(#4) Chain OUT and Control Connector: RJ-45 connector. This connector is
used for distributing power and data to chained Exciters and to connect the
External LF Antenna device. The output voltage is 12 V DC (0.5A maximum).
(#5) Termination Switch: For defining the termination settings in a chained
Exciters installation. The termination of the first and last Exciter in the chain
must be set to On (o-o) and the other Exciters set to Off: (-o-o-).
(#6) IP Reset: Restores the Exciter's IP address to the company-set default
value. See Resetting the Exciter IP Address for details.
EX5200 Exciter Deployment Guide
11