Adjustment Procedure - M-system 48NAR Instruction Manual

ADJUSTMENT PROCEDURE

■ ZERO ADJUSTMENT: Apply 0% input signal before adjustment.
Zero Adjustment
■ SPAN ADJUSTMENT: Apply 100% input signal before adjustment.
Span Adjustment
■ ALARM SETTING: Proceed after the zero / span adjustments.
H Setpoint
* 2 HH Setpoint
L Setpoint
* 2 LL Setpoint
■ POWER SAVING MODE
Indicator OFF
Indicator ON
■ RESET TO FACTORY SETTING *
*1. Keep pressing at least for 3 seconds to activate Mode Selector M. Press briefly for second and more times within 1 minute after it has been activated.
*2. HH or LL setpoints are not provided for the 48NAR-2.
*3. The reset function is used to reset the unit to the factory set temperature range. It does not affect alarm setting.
Note: Each setting sequence is complete only when SET button is pressed. Once set, parameters are not lost even after the power is removed, except
for the power saving mode. The power saving mode is automatically cancelled when the power is reset.
Mode Selector* 1 LED Blinking
M Z
1
Mode Selector* LED Blinking
M S
Mode Selector* 1 LED Blinking
M H
M HH
M L
M LL
Mode Selector* 1 LED Blinking
M •
M •
3
Mode Selector* 1 LED Blinking
M •
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
UP / DOWN Button
Increase / Decrease
Increase / Decrease
Increase / Decrease
Increase / Decrease
LED Blinking Fast
•
Press at once
LED OFF
SET Z
LED OFF
SET S
LED OFF
SET H
SET HH
SET L
SET LL
LED ON
SET •
LED OFF
SET •
LED OFF
SET
•
Press at once
EM-9432 Rev.8 P. 7 / 8
48NAR
Complete
Complete
Complete
Complete
Complete
Complete
Complete
Complete
Complete